how come it shift throw 1 2 3 fine but will not go in to 4th.

2007 HYUNDAI ACCENT
96,000 MILES
Avatar
ACCENT 07
  • MEMBER
  • 1 POST
i change the trans in my car the new one goses in to 123 fine but will not go in to 4th.(The old one would go in to 1&2&that it)them when i stop&take off it stays in 3rd.if I turn off the car&start it it will do the same thing.the code that comes up is p0760scsv c(2nd solenoid)-open/short (that was the same as the last trans.i tested the scsv c and came back fine. could it be what ever tell the trans to shift?
Jan 12, 2012 at 9:39 PM
Advertisement
Avatar
BMRFIXIT
  • ✓ASE Certified Mechanic
  • 19,053 POSTS
  • ASE Certified Mechanic
- Low transmission fluid level
- Dirty transmission fluid
- Faulty shift solenoid C valve
- Shift solenoid C valve harness or connectors
- Shift solenoid C valve circuit is open or shorted
When is the code detected?
The P0760 code is detected when the TCM detects an improper voltage drop when it tries to operate the solenoid valve
Jan 13, 2012 at 12:28 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.