ABS module code C0268?

Hello, I'm Danny.

This video shows the job being done on a similar car but the process is the same. Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.

https://youtu.be/lUotkKXG9dY

Here is the information you requested. I've attached picture steps below on how to change the abs hydraulic unit- modulator valve on your truck below including brake bleeding instructions. Hope this helps and thanks for using 2CarPros. Check out the diagrams (Below).

This fault code refers to the pump motor. The computer monitors feedback voltage on the ground wire when it turns the motor off to determine if the motor is shorted, the circuit is open, or the motor is seized and is not coasting to a stop. You can check the connector terminals for corrosion, but beyond that, you need a dealer-level scanner to perform the diagnostic steps. To add to the misery, a shorted motor can damage the controller. The motor's resistance is supposed to be measured to see if it has shorted, but doing that is not practical. That resistance is supposed to be 0.3 to 1.0 ohms. Your meter's test leads will measure two or three times that much. Even if the motor is shorted, the wiring will have plenty of normal resistance that this test appears to say the motor is fine.

The most accurate way to tell if the motor is shorted is to let the computer figure that out, but if it has been damaged and you replace it, that new computer will likely be damaged too. The safest way is to replace the motor, then if the system still does not work, replace the controller.

Good afternoon,

He is correct. The entire unit should be replaced together. Then the system needs to be bled out.

The bleeding involves using a scan tool to do the automated bleeding procedure.

Roy

Automated Bleed Procedure

Two Person Procedure

Important:
Use the two-person bleed procedure under the following conditions:
Installing a new Electro-Hydraulic Control Unit (EHCU) or new Brake Pressure Modulator Valve (BPMV)
Air is trapped in the valve body
Do not drive the vehicle until the brake pedal feels firm.
Do not reuse brake fluid that is used during bleeding.
Use the vacuum, the pressure and the gravity bleeding procedures only for base brake bleeding.

1. Raise the vehicle in order to access the system bleed screws.
2. Bleed the system at the right rear wheel first.
3. Install a clear hose on the bleed screw.
4. Immerse the opposite end of the hose into a container partially filled with clean DOT 3 brake fluid.
5. Open the bleed screw 1/2 to one full turn.
6. Slowly depress the brake pedal. While the pedal is depressed to its full extent, tighten the bleed screw.
7. Release the brake pedal and wait 10-15 seconds for the master cylinder pistons to return to the home position.
8. Repeat the previous steps for the remaining wheels. The brake fluid which is present at each bleed screw should be clean and free of air.
9. This procedure may use more than a pint of fluid per wheel. Check the master cylinder fluid level every four to six strokes of the brake pedal in order to avoid running the system dry.
10. Press the brake pedal firmly and run the Scan Tool Automated Bleed Procedure. Release the brake pedal between each test.
11. Bleed all four wheels again using Steps 3-9. This will remove the remaining air from the brake system.
12. Evaluate the feel of the brake pedal before attempting to drive the vehicle.
13. Bleed the system as many times as necessary in order to obtain the appropriate feel of the pedal.

The module controls the action of the valves in the hydraulic unit. The issue may be in the hydraulics and the module. That is why I always replace them together.

Roy

If you are talking about the tube adapters then you may be able to order them if they are still available. If not then the hydraulic unit will need to be replaced.

That would be your best bet. They may need to order it if it is still available.