Advertisement

2007 Ford Focus engine

170,000 MILES
Avatar
LEANNAG
  • MEMBER
  • 6 POSTS
Everytime i hit my brakes my car cuts off, sometimes i can be sitting on a hill at a stop light and it cuts off,but it starts back up every time. i have every possible part to fix it any help would be great. thanks leanna
Oct 6, 2013 at 9:05 AM
Advertisement
Avatar
MADMIKE1735
  • ✓Experienced Mechanic
  • 951 POSTS
everytime you hit the brakes it cuts off??? im assuming it shuts off.... if your driving at 40mph for example, and hit the brake pedal to slow to 30mph, does the car still shut off, or is it only doing it when your stopped with your foot on the brake??? do the RPM's drop slowly before it dies??? also, if you step on the gas before it dies, can u keep it running?
Oct 6, 2013 at 9:40 AM
Advertisement
Avatar
LEANNAG
  • MEMBER
  • 6 POSTS
Its when I'm stopped or the car is sitting on a incline. If I hit the gas before it starts to die it is fine. I have replaced fuel pump, air filter, brake line, checked air intake and none of it helped. The rpms do not drop it just cuts off as if I turned it off and for the most part it starts back up without a problem, sometimes it takes a few tries as if its flooded. Thanks so much
Oct 6, 2013 at 10:09 AM
Avatar
MADMIKE1735
  • ✓Experienced Mechanic
  • 951 POSTS
ok, this info will get us a good start... is your check engine light on? why did you replace the fuel pump? was the fuel pressure low, or it was inop? you mentioned you checked the air intake... do you mean the throttle body? its hard to inspect an intake unless its off the car... so far, with the info you have given, im leaning towards the Idle Air Control solenoid....
Oct 6, 2013 at 10:26 AM
Advertisement
Avatar
LEANNAG
  • MEMBER
  • 6 POSTS
We thought it may of been the fuel pump, but we haven't checked what you are leaning towards what does that do?
Oct 6, 2013 at 10:36 AM
Avatar
MADMIKE1735
  • ✓Experienced Mechanic
  • 951 POSTS
it controls your idle speed.... it will be located on your throttle body.... they sometimes get clogged with carbon, and it prevents the pintle from closing completely....
Oct 6, 2013 at 10:43 AM
Advertisement
Avatar
LEANNAG
  • MEMBER
  • 6 POSTS
My husband said they checked that and it was fine we haven't tried the intake manifold gasket and fuel injectors could it be either of these?
Oct 6, 2013 at 10:48 AM
Avatar
MADMIKE1735
  • ✓Experienced Mechanic
  • 951 POSTS
how did they check the IAC? an intake manifold gasket would cause an unmetered air leak, and increase idle.... a bad fuel injector would give a misfire.... im still leaning towards the IAC... they are a pretty common failure.
Oct 6, 2013 at 10:54 AM
Avatar
MADMIKE1735
  • ✓Experienced Mechanic
  • 951 POSTS
While the problem is occurring, keep the engine running by giving it just enough throttle to keep it from stalling. With the Idle Air Control (IAC) valve connected, monitor the voltage across the 2 wires at the IAC valve connector. The higher the voltage, the harder the Powertrain Control Module (PCM) is trying to raise the idle. Expect more than 4 volts if the idle is lower than normal. Then, with the engine running at a low idle speed, unplug the connector, and if the RPM does not drop when the connector is unplugged, replace the IAC valve.
Oct 6, 2013 at 10:55 AM
Advertisement
Avatar
LEANNAG
  • MEMBER
  • 6 POSTS
When its on a incline, it starts shaking and then cuts off could that be a misfire?
Oct 6, 2013 at 11:01 AM
Avatar
MADMIKE1735
  • ✓Experienced Mechanic
  • 951 POSTS
it sounds like it is.... if you have access to a snap on modis, or an OTC genisys, you can get into mode 6 data.... check monitor $53 as on a ford, this is the misfire monitor.... there will be more of a load on the engine on an incline, but the shaking could also be the rpms dropping under 500, and then it stalls...
Oct 6, 2013 at 11:05 AM
Advertisement
Avatar
LEANNAG
  • MEMBER
  • 6 POSTS
Ok we will try to find one. Thank you so much for your time and opinions. This has been happening for 2 years and we are just out of options as to what else to replace. We will try what you suggested and maybe replace the fuel injector. Thank you again and have a good night.
Oct 6, 2013 at 11:13 AM
Avatar
MADMIKE1735
  • ✓Experienced Mechanic
  • 951 POSTS
dont replace any of the fuel injectors unless you know for certain one has failed... mode 6 will show any misfires as i said.... from there we narrow down the cause of the misfire, if there is one.
Oct 6, 2013 at 11:17 AM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle