engine noise

2007 FORD F-150
74,000 MILES • V8 • 4WD • AUTOMATIC
Avatar
STEVEJ81
  • MEMBER
  • 1 POST
about three days ago i was pulling my trailer through the west virginia mountains, when i heard a noise which sounded like my trailer chains dragging on the ground but it was coming from the drivers side of the engine. it only happened when i was accellerating up a hill or when i would hit the gas. when i would let off the gas pedal the noise would stop. i kinda check the pulley assembly for some looseness but i didnt dig into it really far, but it seemed fine. any recommandations?
Thanks for your time
Mar 16, 2011 at 2:09 PM
Advertisement
Avatar
MERLIN2021
  • ASE Certified Mechanic
  • 17,250 POSTS
  • ASE Certified Mechanic
engine ping perhaps?
Mar 16, 2011 at 2:16 PM
Avatar
NICKB275
  • MEMBER
  • 24 POSTS
Try using higher octane gas to see if this broken bottle sound goes away. Do you have a check engine light on? May have a knock sensor code. If the knock sensor is out in this engine, you will have knocking/pinging noise as ECM cannot detect knock/ping and correct timing, which is ECM adjusted only.
Mar 16, 2011 at 2:39 PM
Avatar
RIVERMIKERAT
  • ASE Certified Mechanic
  • 6,110 POSTS
  • ASE Certified Mechanic
A sound like trailer chains dragging. Check the heat shields on the exhaust system for loose or missing tack welds. Fords are notorious for this and have been since the inception of catalytic converters.

Check the timing. Make sure it's set right and advancing properly under acceleration/load.

How regular is the sound? does it sound rhythmic or is it random?
Jun 15, 2011 at 4:48 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.