AC only blows warm air?

2007 FORD FIVE HUNDRED
129,700 MILES • 3.0L • V6 • FWD • AUTOMATIC
Avatar
CMAKLE
  • MEMBER
  • 1 POST
AC was checked for leaks, and none were found,freon was supplied, but AC only blows warm air. The high AC button is not working now, but it still works when AC is not engaged. The front of radiator was flushed with water to unclog any road grime, but nothing changed. The AC blows slightly cooler when driving on highway, but not like it is supposed to. I was told that I need a new compressor and accumulator, but I am not sure, please help.
Jun 8, 2015 at 1:31 PM
Advertisement
Avatar
HMAC300
  • ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
On this you really need to know if the compressor is working or not. meaning you need to know high and low pressures. If your large line going into evaporator is sweating /frosting up then it may be an actuator not an accumulator with key on pull fuse 7 and fuse 20 it may reset the actuators for temp. there are two actuators one for lh and one for rh.
Jun 8, 2015 at 3:21 PM
Avatar
DAVENOOB
  • MEMBER
  • 333 POSTS
Is this the same with a 2005? Is this the fusebox in the engine or inside of passenger side of car?
Dec 3, 2024 at 9:34 AM
Avatar
STRAILER
  • ASE Certified Mechanic
  • 54,832 POSTS
  • ASE Certified Mechanic
Fuse #7 and fuse #20 are in the smart junction box on the inside of the car. Here are the fuse locations and a guide on how to test them:

https://www.2carpros.com/articles/how-to-check-a-car-fuse

Check out the images (below). Let us know if you need anything else.
Dec 3, 2024 at 10:29 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.