2007 BMW 320D
75,000 MILES
Avatar
JASMINE_KPATEL
  • MEMBER
  • 5 POSTS
bmw 320d cranking but not started.vehicle is automatic transmission
Apr 10, 2013 at 8:53 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Go to this walk thru link: https://www.2carpros.com/articles/car-cranks-but-wont-start
Apr 10, 2013 at 9:06 AM
Advertisement
Avatar
JASMINE_KPATEL
  • MEMBER
  • 5 POSTS
thanks for answer.but at primery level i had check all the things like fuses,power and etc.the error is given below.
1.ecu internal fault
2.oxygen sensor heating
3.boost pressure sensor short to earth
Apr 10, 2013 at 10:53 AM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
What are the exact codes?
Apr 10, 2013 at 10:55 AM
Avatar
JASMINE_KPATEL
  • MEMBER
  • 5 POSTS
4207 oxygen sensor heating open circuit....4191 boost pressure actuator short circuit to earth..... 4A63 signal immobilizer manipulated Switch code is faulty....449A charge pressure actuator position sensor open circuit....4656 control unit internal fault....4212 glow plug,cyl.1 open circuit.... 4222 glow plug,cyl.2 open circuit...4232 glow plug,cyl 3 open circuit....4242 glow plug,cyl.4 open circuit
Apr 10, 2013 at 11:12 AM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
I recommend you have the control unit further checked out-
Apr 10, 2013 at 7:19 PM
Avatar
JASMINE_KPATEL
  • MEMBER
  • 5 POSTS
O.k.but how can i check the ecu.can u know me if any procedure for that.
Apr 11, 2013 at 3:31 AM
Avatar
JASMINE_KPATEL
  • MEMBER
  • 5 POSTS
Dear rasmataaz,
Did u find any clu of check the ecu...
Apr 11, 2013 at 4:59 AM