I then tried to start the car but it would start?

Tiny
RYGUY285
  • MEMBER
  • 2006 VOLKSWAGEN PASSAT
  • 2.0L
  • 4 CYL
  • TURBO
  • FWD
  • AUTOMATIC
  • 82,000 MILES
So I changed a can sensor and changed the valve on the turbo after word the battery died So I charged it and took it to autozo e they tested the battery and said it was fine but I have. A draw. So I went home and did a draw test but not one fuse showed a draw I then tried to start the car but it would start then stall I checked the battery it was at 11.5 volts so I charged it and no matter what I did it wouldn't hold a charge over 11.7volts so I need to replace the battery and now Help.
Friday, December 4th, 2015 AT 8:57 PM

2 Replies

Tiny
CARADIODOC
  • MECHANIC
  • 33,916 POSTS
If you didn't use some type of memory saver device, most likely you have some computers that are locked up. This video shows the job being done on a similar car but the process is the same.

https://youtu.be/PO2OVeLfl-o

Here is a guide to help you step by step with instructions in the diagrams below to show you how on your car.

https://www.2carpros.com/articles/how-to-replace-a-car-battery

Check out the diagrams (Below). Please let us know what happens.
Was this
answer
helpful?
Yes
No
Monday, December 7th, 2015 AT 8:23 PM
Tiny
RYGUY285
  • MEMBER
  • 2 POSTS
Yeah I agree it's on the way the the dealer this morning gotta get it on the road to put my trans am away. I'm pretty sure your right it's a computerproblem I reset the codes but it still won't start needs a more in-depth look.
Was this
answer
helpful?
Yes
No
Tuesday, December 8th, 2015 AT 7:00 AM

Please login or register to post a reply.

Sponsored links