showing a p0301 trouble code misfire on cylinder 1

2006 SATURN ION
128,000 MILES
Avatar
HEYSECRET
  • MEMBER
  • 1 POST
I have a 2006 Saturn ion - my autoxray machine shows no power to injector #2 the injectors ohm out ok

The car runs rough at start up and idol and has trouble accelerating but runs smooth when up to speed i have also installed new spark plugs.
Nov 22, 2011 at 5:00 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
That is a cylinder 1 misfire. Check compression in that cylinder, check coil... If you already replaced the plugs, check to make sure it is getting a good hot blue snapping spark to that cylinder and make sure the injector is getting power.
Nov 22, 2011 at 5:01 PM
Advertisement
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
Just to add to this one i have seen some of the newer ions have low compression on a cylinder causing a dead hole.Also as far as checking the injector circuit best to use a noid light it shoukd flash while cranking and not stay on solid.
Nov 22, 2011 at 5:45 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
That is what I was thinking too, Saturntech. Thanks for the input.
Joe
Nov 22, 2011 at 5:52 PM