how tight bolt through lower control arm bushing should be on 2006 g6

2006 PONTIAC G6
55,000 MILES
Avatar
CFREDRICK
  • MEMBER
  • 1 POST
installed the drivers side lower control arm and was wondering how tight the bolt (which is part of the assembled arm) that goes through the bushing inside the mounting bracket should be.
Feb 12, 2012 at 7:33 PM
Advertisement
Avatar
FIXITMR
  • ✓Experienced Mechanic
  • 9,990 POSTS
tight enough to hold the bushing central tube from turning under suspension twist. and it should be done when suspension is in normal position on road surface.
Feb 12, 2012 at 9:38 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.