Steps on refilling cooling system on a 2006 Pontiac g6 after changing thermostat?
Dec 3, 2012 at 5:12 AM
How to refill the cooling system?
2006 PONTIAC G6
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
STRAILER
- ✓ASE Certified Mechanic
- 54,840 POSTS
Hello,
Start by refilling the system until full. Then start the engine and allow to run until hot. Continue to fill the system. At this point if there is a bleeder screw at the thermostat housing open it to allow any air to escape (some don't have it). Top the coolant of and install the cap.
Here is a guide that will help you.
https://www.2carpros.com/articles/coolant-flush-and-refill-all-cars
Please let us know if you need anything else to get the problem fixed.
Cheers, Ken
Start by refilling the system until full. Then start the engine and allow to run until hot. Continue to fill the system. At this point if there is a bleeder screw at the thermostat housing open it to allow any air to escape (some don't have it). Top the coolant of and install the cap.
Here is a guide that will help you.
https://www.2carpros.com/articles/coolant-flush-and-refill-all-cars
Please let us know if you need anything else to get the problem fixed.
Cheers, Ken
Jun 26, 2017 at 9:20 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.