Squeaky Brakes

2006 NISSAN 350Z
26,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
MARK MANION
  • MEMBER
  • 1 POST
I have an 06 Nissan 350Z with the Brembo calipers. I replaced the front & rear disc pads. I did not have the rotors machined as all appeared to be in good condition. The rear brakes are squeaking, upon slowing to a stop. (The front brakes are fine.) Any ideas are how I can eliminate the squeaking?

Thank you, Mark Manion
Dec 20, 2010 at 8:32 PM
Advertisement
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
Yup. Did you use high-temperature brake grease on the backing plates of the pads and on the caliper mounts? Also, use sandpaper, a flat file, or rub the leading edges of the linings on cement to break the sharp edges. That will eliminate the "fingernails on the blackboard" squeal.

Be sure to wash off any grease from the pad linings and rotor surfaces.

caradiodoc
Dec 20, 2010 at 8:59 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.