gear box

2006 MITSUBISHI MAGNA
6 CYL • FWD • MANUAL
Avatar
CHANGTE
  • MEMBER
  • 32 POSTS
I want to replace clutch kit, but the gear box can't pull out.
I check the new kit,found the bearing will lock on the pressure plate when box fit in.
now I am stuck,the fork is stuck there too,
someone could help me? urgent.
Aug 13, 2011 at 1:29 AM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
This will by a "pull type clutch" I presume that you are in Aust? as Magna is not on the US market, looking at the US data base for Mitsubishi, i can see pull type clutches that are used, with these you remove the slave cylinder, and remove the dust boot over the clutch lever, looking in side you should see a clip that locks the fork onto the pivot, pull this clip and the fork will remove out of the thrust and the box will then be free to remove.
Aug 13, 2011 at 6:06 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.