Drive train

2006 LEXUS IS 250
102,000 MILES
Avatar
SHABIRIS250
  • MEMBER
  • 8 POSTS
Had a new clutch, flywheel and clutch release bearing installed due to a high clutch pedal and judder through car when setting off.

After the install i still experience the same problems they have tried bleeding the clutch slave cylinder and this hasnt improved things

What else can i try? Car is a manual transmission

Thanks
Oct 4, 2011 at 6:02 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Did they replace the pressure plate?
Oct 4, 2011 at 9:06 PM
Avatar
SHABIRIS250
  • MEMBER
  • 8 POSTS
Yes they did it was a full clutch kit
Oct 4, 2011 at 9:28 PM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
If everything was installed correctly (with a new flywheel), there shouldn't be a chatter when you pull out. As far as adjustment, the only thing I can say is try to rebleed the system at the slave cylinder. That, however, will not get rid of a chatter.
Oct 4, 2011 at 9:30 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.