my 2006 tiburon wont start

2006 HYUNDAI TIBURON
150,000 MILES
Avatar
NASCARS3N8
  • MEMBER
  • 6 POSTS
My 2006 tiburon wont start. It turns over but its not sparking. We have tried replacing the cqm and crank sensors, plugs and wires and also the coil pack. What else could it be?
Jan 30, 2012 at 4:01 PM
Advertisement
Avatar
DOCFIXIT
  • ASE Certified Mechanic
  • 18,828 POSTS
  • ASE Certified Mechanic
Check engine light on? codes?
Jan 30, 2012 at 6:29 PM
Avatar
NASCARS3N8
  • MEMBER
  • 6 POSTS
Yes. The check engine light has been on. It was throwing the code for the crank sensor and o2

Jan 30, 2012 at 10:05 PM
Avatar
CADIEMAN
  • ASE Certified Mechanic
  • 3,544 POSTS
  • ASE Certified Mechanic
spray the intake does it start?
Jan 30, 2012 at 10:11 PM
Avatar
NASCARS3N8
  • MEMBER
  • 6 POSTS
no. tried starter fluid and got nothing
Jan 31, 2012 at 4:38 AM
Avatar
CADIEMAN
  • ASE Certified Mechanic
  • 3,544 POSTS
  • ASE Certified Mechanic
check the crank sensor installaion.its not going to start with the code set.
Jan 31, 2012 at 5:42 PM
Avatar
NASCARS3N8
  • MEMBER
  • 6 POSTS
We unhooked the battery but still nothing
Feb 2, 2012 at 12:03 AM
Avatar
XTREMEVERT
  • MEMBER
  • 2 POSTS
I have the exact same problem with my 2003. took it to the dealership and had the exact same codes come up. replaced the crank sensor and still nothing. no spark either. did you find out what the problem is?
Apr 25, 2012 at 4:41 AM
Avatar
XTREMEVERT
  • MEMBER
  • 2 POSTS
check the crank sensor installaion.its not going to start with the code set.

what does this mean exactly?
Apr 25, 2012 at 4:47 AM
Avatar
MULE MEAT
  • MEMBER
  • 1 POST
Look at the coil pack. The plug between the coil pack and wiring harness is pulled so tight that the wires on the coil pack rub and short out or break where they enter the connector. I have found this problem on five 1991 to 2005 model Tiburon's within the past year. The engines would crank over but not run.

Try removing the wiring connector from the bracket (circled in red) on the coil pack. Using your finger. Slide it between the wire and coil pack along the length of the wire to make sure that it is not touching anything. At the connector itself. Straighten the wires so that they are entering the connector as straight as possible. Then try starting the engine again.
May 8, 2012 at 9:47 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.