2006 Holden Commodore Replace Engine

2006 HOLDEN COMMODORE
150,000 MILES • 3.6L • 6 CYL • RWD • AUTOMATIC
Avatar
ALI12
  • MEMBER
  • 2 POSTS
Hi, I Replaced the Holden Commodore VZ Engine with second hand Engine of Same LEO motor. After fitting everything back, I couldn't Start the Engine. Its cranking, Got spark, Fuel pressure is about 350 PSI when Cranking. I check the injectors it all working. Oh to make Sure ECU of car is same as old one.
Can Anyone suggest me what I do? Please
Mar 19, 2014 at 1:20 AM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
If it is pulsing the injectors and not firing it will be flooded, check that the plugs are not wet with fuel, also if you do have spark, injector pulse and fuel pressure, run a scan for any fault codes, let me know what codes are set,
Mar 19, 2014 at 2:32 AM
Avatar
ALI12
  • MEMBER
  • 2 POSTS
Injector is pulsing, and Also got spark but the spark Plugs are wet with fuel.
I did scan witj Snap on OBD 2, but No code is showing.
Mar 19, 2014 at 4:03 AM
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
clean plugs and try again, it may just be very flooded.
Mar 19, 2014 at 4:13 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.