2006 GMC Truck rough running, oil consumption

2006 GMC TRUCK
220,000 MILES • 6.0L • V8 • 4WD • AUTOMATIC
Avatar
ALLENGG1
  • MEMBER
  • 1 POST
did headgaskets truck was fine, now running rough and consuming oil, seems to be getting sucked into the intake, this particular engine does not use a conventional pcv valve, what could the problem be
Jan 11, 2015 at 11:31 PM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
check the hose for blockage which is pcv return and it may be a gasket rubberon intake has slipped causing a vacuum leak. I assume truck has been scanned for codes and fuel pressure h as been checked with a gauge
Jan 11, 2015 at 11:49 PM
Avatar
JOHNNYT73
  • ✓Experienced Mechanic
  • 924 POSTS
I believe there may be a bulletin out for this issue. Using redesigned valve covers to correct the oil consumption issue.
Jan 12, 2015 at 12:25 AM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
truck must sit 15 minutes prior to checking oil per one tsb and on level ground as well as the pcv system must be checked for blockage which I've already sent the pic of where the hose is. The other tsb is essentially the same it just covers towing and higher rpm 3000 and above wil give you heavier oil ususage. IF not good do a consumption test on it.
Jan 12, 2015 at 1:43 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.