2006 Ford Taurus AIR BAG CODE 1892 HOW DO I REPAIR IT

TOM OLDS

MEMBER
2006 FORD TAURUS
146,000 MILES

I have a 2006 ford taurus 3.0 v-6 automatic tranmission.I have a airbag light on and I pulled the code. It has code b1892 but can not find any info on how to repair. Can anyone help please?

Wednesday, May 9th, 2012 AT 4:02 PM

2 Replies

FIXITMR

MECHANIC
9,990 POSTS

Air Bag Tone Warning Indicator Circuit Shorted to Ground or Open

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

Wednesday, May 9th, 2012 AT 5:22 PM

FIXITMR

MECHANIC
9,990 POSTS

CHECK THE AIR BAG TONE WARNING INDICATOR CIRCUIT FOR GROUND SHORT
NOTE: If a seat equipped with a seat mounted side airbag and/or a safety belt pretensioner (if equipped) system is being serviced, the airbag system must be deactivated. Refer to Air Bag and Safety Belt Pretensioner Supplemental Restraint System (SRS) Air Bag and Safety Belt Pretensioner Supplemental Restraint System (SRS) in this section.
NOTE: Restraint system diagnostic tools MUST be installed under the seats in the side airbag and safety belt pretensioner (if equipped) to floor connectors.
NOTE: Diagnostics or repairs are not to be performed on a side airbag system and/or a safety belt pretensioner (if equipped) system with the seats in the vehicle. Prior to attempting to diagnose/repair the side airbag system and/or a safety belt pretensioner (if equipped) system the seats must be removed from the vehicle and the restraint system diagnostic tools must be installed in the side airbag and the safety belt pretensioner (if equipped) connectors at the floor connectors. The restraint system diagnostic tools must be removed prior to operating the vehicle over the road.
NOTE: Diagnostics may be performed on seat systems other than the side airbag or the safety belt pretensioner (if equipped) system (lumbar, climate controlled, heated, power seat track) with the seat installed in the vehicle as long as the restraint system diagnostic tools are installed under the seats in the side airbag and safety belt pretensioner to floor connectors.

Measure the resistance between RCM C310a pin 11, circuit 1083 (LB/BK), harness side and RCM C310a pin 10, circuit 649 (BK/OG), harness side.

Is the resistance less than 10,000 ohms?
Yes
REPAIR the ground short on circuit 1083 (LB/BK). GO to C6.

No
GO to C3.

Measure the resistance of circuit 1083 (LB/BK) between RCM C310a pin 11, and GEM C201c pin 16.

Is the resistance greater than 10 ohms?
Yes
REPAIR the circuit. GO to C6.

No
GO to C4.

Measure the voltage at RCM C310a pin 11, circuit 1083 (LB/BK).

Is the voltage less than 1.0 volt?
Yes
INSTALL a new GEM. GO to C6.

No
INSTALL a new RCM. GO to C6.

Was this

answer