2006 Ford Ranger Truck stall

2006 FORD RANGER
193,000 MILES
Avatar
DAORT
  • MEMBER
  • 1 POST
My truck was running fine. I connected a diagnotic monitor that I just received. It was marking zero problem code. However, after a while my truck began to shake and then it stalled. Now I am not able to re-start it. The engine will turn but will not start. Did the diagnostic handheld device damagae my truck's computer? I disconnected and reconnected the battery hoping to re-set the truck computer and it still will not start. How can I fix this?
Jul 18, 2013 at 2:20 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
As long as you didn't change any parameters in the computer, the scanner shouldn't have caused this issue. Have you checked to see if the fuel pressure is within spec as well as are you getting spark to the plugs?
Jul 18, 2013 at 3:41 PM
Advertisement