Horn Inop

DAVE HOGGE

MEMBER
2006 FORD FUSION
FWD
48,000 MILES

How do I access the horn assembly on a 2006 Ford Fusion to check if it needs replacement? The car was wrecked and rebuilt. It was inspected and passed but I have yet to be able to to blow the horn. This also affects my Alarm. I cannot find any books available to help me with this. I checked the fuse and have tried to remove the headlight assembly but stopped when it didnt come out easily. Please advise. Thanks in advance.

2 Replies

RASMATAZ

MECHANIC
75,992 POSTS

Could be the ground circuit, horn, horn relay and horn button switch

Removal and Installation

With the vehicle in NEUTRAL, position it on a hoist.
Remove the 4 RH front fender splash shield screws.
Pull the RH front fender splash shield downward to access the horn.
Disconnect the electrical connector.
Remove the bolt and the horn.
To install, tighten to 10 Nm (89 lb-in).
To install, reverse the removal procedure.

Image (Click to make bigger)

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

+1

Thursday, December 30th, 2010 AT 10:18 PM

SATURNTECH9

MECHANIC
30,869 POSTS

Here is how you get to the horn.I also posted the wire diagram for the horn. Let me know what you find.
Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 4 RH front fender splash shield screws.

O Pull the RH front fender splash shield downward to access the horn.

3. Disconnect the electrical connector.
4. Remove the bolt and the horn.

O To install, tighten to 10 Nm (89 lb-in).

5. To install, reverse the removal procedure.

Image (Click to make bigger)