SPONSORED LINKS

2006 Ford Fusion codes keep coming back

Tiny
ANDERSONBRYAN19
  • MEMBER
  • 2006 FORD FUSION
  • 2.3L
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 100,000 MILES
I keep getting code p0420 and code p0010 when I scan my fusion, I replaced the cam shafts positioning sensor and the upstream 02 sensor and cleared the codes but when I drive the car then stop and start it again the codes come right back, don't know what I'm over looking, any ideas? Oh and the car runs fine so I don't think it's the catylac converter being clogged.
SPONSORED LINKS
Monday, October 26th, 2015 AT 11:18 AM

1 Reply

Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
The converter does not have to be clogged to be bad. The code means it's just not chemically doing it's job.
The other code is for a cam actuator circuit. Nothing to do with a cam position sensor
Was this
answer
helpful?
Yes
No
Monday, October 26th, 2015 AT 4:37 PM

Please login or register to post a reply.

Related Camshaft Camshaft Sensor Replace/Remove Content

Camshaft Position Sensor Replacement
GUIDE
Camshaft Position Sensor Replacement
Replacing an engine camshaft position sensor is a critical maintenance task that can restore your vehicle's performance and fuel efficiency. A faulty camshaft sensor can...
VIEW MORE

Sponsored links