I need to find the ABS module replacement instructions

Good afternoon,

I attached the procedure with a picture of the unit below.

https://www.2carpros.com/articles/how-to-replace-a-abs-controller

Let us know if there is anything else we can help you with.

Roy

Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Push the lock forward and release the ABS electrical connector.
3. Remove the screws and the ABS module.
To install, tighten to 3 Nm (27 inch lbs.).
4. To install, reverse the removal procedure.