4x4issue

2006 DODGE TRUCK
98,000 MILES
Avatar
DGOLDENBERG1213
  • MEMBER
  • 17 POSTS
06 2500 power wagon, 5.7 hemi, 4x4
service 4x4 light is on, says I'm in 4x4 mode when I'm not.
The switch for the front electric sway bar, continually flashes
and does not turn on or off, just blinks.

Thoughts please??

Thank You
Dave,G.
dgoldenberg1213@hotmail.com
Sep 22, 2011 at 12:57 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
You need to have the computer scanned to identify where the problem is coming from. Chances are there is a sensor that is bad.
Sep 22, 2011 at 1:05 AM
Advertisement
Avatar
DGOLDENBERG1213
  • MEMBER
  • 17 POSTS
is there a scanner I can buy for this, my ob2 scanner works on engine and other codes, but is not picking up the drive train??
The dealer wants way to much to do just the dio;
I have seen some blogs about re-flashing the drive train on dodges, but the dealer also wants an arm and leg to do this, can I reflash and upgrade the firmware/program myself??
Thanks again
Dave,G.
dgoldenberg1213@hotmail.com
Sep 22, 2011 at 1:34 AM
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Yes, but they are very expensive. They read everything from engine, AC, trans, ABS...
Sep 22, 2011 at 2:03 AM