2006 Dodge Stratus Fans

check to see if pcm is telling relay to put the fan on . you can get the numbers off of the relay on bottom. if it is land you've replaced the relays then they aren't making good contact in fuse box so try tweeking the prongs a tad and putting dielectric compound on them so they will make good contact. it may be your coolant temp sensor may not be working either but if you get a signal at relay then the temp sensor is working.

Thanks For The Diagram. But I Don't Know If I Am Using The Right Relays For The Low And High Fans To Be Able To Work. These Relays Were Already In Vehicle When I Bought It. For All I Know They Could Be The Wrong Relays That Need To Be Used. All Of These Relays Have Two Numbers That Are The Same. The Top Number Is 56006709 And The Second Number Is 50732, But There Are Some Numbers That Have Been Stamped On The Bottom Below These Other Two Numbers And All Of These Numbers Are Different From Each Other. Do You Have The Correct Numbers For The Relays That Operate The High And Low Radiator Fans For This Vehicle ? And Thanks For your Help That You Have Already Given Me.

here are a cole different relay s which we don't have the numbers autoparts has that stuff we just fix the cars not know part numbers all the time.

Thanks For This Info. I Need A Little Help With Names Of The Things That Are Plugged Into The Middle Row Inside The Fuse & Relay Center Box. I Looked Online Under How To Test A Car Fuse With A Test Light. A Video Appeared That Listed All The Plugin In The Second Row Over To The Right Over From The Fuel Pump , Starter, Eatx Relays As Fuses And Went On To Show How To Test These Fuses With A Test Light. But The Ones In The Middle Row Were Not Shown. So What I Am Asking If These Are Not Fuses, What Are They Called And Can They Be Tested With A Test Light ? I Am Really Sorry To Be So Much Trouble To You.

where the are pointing in fuse box those are maxi fuses and can be tested with a test light. if you have a manual they will be listed as to what they are

Thank You Very Much, This Info Is Just What I Needed. Also I Do Have The Manuel That Shows What They Are For. Thanks Again.

kind of tough task to do but i think you should run a toggle switch to turn on the fans thats what im going to do. better to have the fans crap out instead of car with aluminum heads get damaged with excessive heat.