Oxygen sensor wiring diagram?

2006 DODGE CHARGER
50,000 MILES
Avatar
DONNIESHARI
  • MEMBER
  • 1 POST
need to know which fuse sends power to the o2 sensor.
Jan 15, 2013 at 6:48 PM
Advertisement
Avatar
DOCFIXIT
  • ASE Certified Mechanic
  • 18,828 POSTS
  • ASE Certified Mechanic
The oxygen sensors are power by the PCM here is a engine wiring diagram so you can see how the system works with a guide on how to change an oxygen sensor

https://www.2carpros.com/articles/how-to-replace-an-oxygen-sensor

Check out the diagrams (Below)

Please let us know if you need anything else to get the problem fixed.

Cheers
Jan 15, 2013 at 8:02 PM
Avatar
KISERJOY
  • MEMBER
  • 3 POSTS
Does anyone know where i can get the wiring diagram for the fuel pump and can anyone help me find the right way the gas line goes to the carburator? just put another motor in it but can not figure why thw electric fuel pump is not kicking in. thank you
Dec 16, 2020 at 8:05 AM (Merged)
Avatar
LOSONE
  • ASE Certified Mechanic
  • 1,616 POSTS
  • ASE Certified Mechanic
Are you sure you have a carburator? The only vehicle in 88 that was carburated was the ram 50. It is supposed to have a throttle body.
Dec 16, 2020 at 8:05 AM (Merged)
Avatar
KISERJOY
  • MEMBER
  • 3 POSTS
it has a throttle body. is there a certain way the fuel line goes?
Dec 16, 2020 at 8:05 AM (Merged)
Avatar
LOSONE
  • ASE Certified Mechanic
  • 1,616 POSTS
  • ASE Certified Mechanic
The big line is from the pump and it goes on the big line at the throttle body. The small line is the returnline. It goes on the small line connector. Good luck
Dec 16, 2020 at 8:05 AM (Merged)
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.