Chrysler T&C door handle

2006 CHRYSLER TOWN AND COUNTRY
68,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
RFORTE129626
  • MEMBER
  • 1 POST
2006 Chrysler Town & Country
I replaced the power windod motor and it works fine. However the rod that connects the inside door handle to the actuator disconnected and I don't know where it connects to.
Feb 21, 2011 at 6:24 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
the should be a little protrusion at the inside for the rod to connect to. the picture that i'm enclosing where you need to connect is item 4 on the drawing.
Image (Click to enlarge)
Attached Media
Feb 21, 2011 at 7:27 PM
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
Sorry, id din't read it right. the next time just go to reply and i'll get this message. Unfortunately I'm in florida right now and won't be back for a week. If you still want to contct me about this i will send it as soon as I get home. sorry again for not givingyou the correct answer. I'll see if Mike can fix this for you sooner though......
Feb 22, 2011 at 8:23 PM
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
ok here is th latch assy. I got hte program loaded taht i needed. if it's not enough email back and i'll get more if i can....
Image (Click to enlarge)
Attached Media
Feb 23, 2011 at 12:27 AM