Advertisement

the car was still running but i wasn't going anywhere?

122,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
ELEANORM
  • MEMBER
  • 1 POST
I was driving kinda slow about to turn, and i pushed on the gas and it did nothing, the car was still running but i wasn't going anywhere. Now it won't start. its throwing out p0340. But we changed all the sensors, and its not the fuel pump. We don't know what else to do, we have tried everything.
Jul 31, 2014 at 7:16 AM
Advertisement
Avatar
DANNY L
  • ✓Experienced Mechanic
  • 5,648 POSTS
Hello, I'm Danny.

Here is the information you requested. Code P0340 is a camshaft position sensor fault code. Here is a tutorial showing how to replace a camshaft sensor:

https://www.2carpros.com/articles/camshaft-angle-sensor-replacement

You will need to check some electrical circuits for this code so here is a tutorial showing how to test electrical wiring.

https://www.2carpros.com/articles/how-to-check-wiring

I've attached a diagnostic picture flow chart below for code P0340 on your Sebring. I've also attached below the picture steps on replacing the camshaft position sensor including its location. Hope this helps and thanks for using 2CarPros.
Sep 13, 2021 at 10:43 PM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle