2006 Chrysler PT Cruiser PT Cruiser

Tiny
ZEMORZEMOR
  • MEMBER
  • 2006 CHRYSLER PT CRUISER
  • 2.4L
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 96,000 MILES
The starter relay I located at the firewall. The car wont start intermittently, before I replaced the ignition switch. When I put the key in the lock cylinder I feel there is a play. When I turn the key to the start position and push it toward me the car starts otherwise it wont.

.I m asking this question because the car has p0884 p0882. P0552 p01603. U101 p0714 p0218. Almost all of them they are related to low voltage. Could be the intermitlly no start problem causes all these codes
Thursday, October 1st, 2015 AT 7:45 AM

5 Replies

Tiny
CAR-MAN145
  • MECHANIC
  • 321 POSTS
Yes they could all be due to a bad ignition switch that's where I would start
Was this
answer
helpful?
Yes
No
Tuesday, December 20th, 2016 AT 6:03 PM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
The car has two more codes p3432 and c0147 I could not find definition and explanation for them

thnak you
Was this
answer
helpful?
Yes
No
Tuesday, December 20th, 2016 AT 6:03 PM
Tiny
CAR-MAN145
  • MECHANIC
  • 321 POSTS
I could not find them on the site either
Was this
answer
helpful?
Yes
No
Tuesday, December 20th, 2016 AT 6:03 PM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
When I turn the key to the run position engine not running all gears in the dash board re selected sometimes they disappear, the battery light stays on and the airbag light too, the security key red dot flashes however the car starts. Bit it goes to limp mode:(
Was this
answer
helpful?
Yes
No
Tuesday, December 20th, 2016 AT 6:03 PM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
In the pcm there is a gel my question is what is the purpose of it, how to remove it and do I need to replace it after pcm repair
Was this
answer
helpful?
Yes
No
Tuesday, December 20th, 2016 AT 6:03 PM

Please login or register to post a reply.

Sponsored links