2006 Chrysler Pacifica won't rev above 3000

Tiny
WITHAM
  • MEMBER
  • 2006 CHRYSLER PACIFICA
  • 3.5L
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 150,000 MILES
Driving home car all of a sudden would not accelerate pulled car into driveway. Put car in park won't rev past 3000 and then starts to waivier. Turned car off. Starts right up. If it is a computer issue can I disconnect battery and clear the issue
Thursday, November 26th, 2015 AT 5:02 PM

4 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
If I recall, on these engines, the crank sensor controls ignition and injection up to around 2500 RPMs. After that, the cam sensor takes over. Is the check engine light on? Also, do you have access to a real time scanner that you can watch to see if there is a signal from the cam sensors?

It is also equipped with a rev limiter that will keep the RPM's from going too high when in Park or Neutral

See the guide below, it may help you figure out the issue

https://www.2carpros.com/articles/checking-a-service-engine-soon-or-check-engine-light-on-or-flashing
Was this
answer
helpful?
Yes
No
+1
Thursday, November 26th, 2015 AT 7:27 PM
Tiny
PAULBARR
  • MEMBER
  • 1 POST
  • 2005 CHRYSLER PACIFICA
  • 56,000 MILES
In neutral it will not rev overr 3000 rpm and souns like oscilating
Was this
answer
helpful?
Yes
No
+6
Friday, October 19th, 2018 AT 5:25 PM (Merged)
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Have the cat converter checked for being clogged

Roy
Was this
answer
helpful?
Yes
No
+1
Friday, October 19th, 2018 AT 5:26 PM (Merged)
Tiny
DEFISHINSEA
  • MEMBER
  • 1 POST
The car comes with a rev limiter from the factory. The oscillating sound is normal. What's the point of revving the engine in neutral though?
Was this
answer
helpful?
Yes
No
+1
Friday, October 19th, 2018 AT 5:26 PM (Merged)

Please login or register to post a reply.

Sponsored links