2006 Chrysler 300 Just Installed Re Manufactured Engine Base 2 7l Everything

2006 CHRYSLER 300
89,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I JUST INSTALLED A RE-MANUFACTURED ENGINE in my 2006 Chrysler 300 base 2.7L.
everything went well, but it is still running rough.
It is putting out 2 codes 1. PO201-"injector circuit malfunction cylinder #1" and PO303- "cylinder #3 misfire detected". so far, I have replaced the fuel injector and the coil on number 1.Also, When I have the engine running at idle and pull connection wire to the coil, the rpm's drop, like they should. when I put the connection back on, rpm's increase, like it
should
Nov 17, 2012 at 2:49 AM
Advertisement
Avatar
ASEMASTER6371
  • ✓ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
still running rough??? please explain

look for vacuum leaks for the missfire.

what did you do for the injector issue???

Roy
Nov 17, 2012 at 3:24 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.