When I turn on left blinker dash board indicator flashes real fast and only the front left turn signal does not flash. All ready donated.
Dec 10, 2011 at 6:36 PM
How do I replace front left turn signal/running light.
2006 CADILLAC STS
CHAD DOOLEY
- MEMBER
- 1 POST
Advertisement
RIVERMIKERAT
- ✓ASE Certified Mechanic
- 6,110 POSTS
Open the hood, locate the plug/pigtail for that signal/indicator, and turn it counterclockwise 90 degrees and remove it from the light housing. Using a tissue or napkin, remove the bulb. It may just pull straight out, or it may need to be turned counterclockwise. Don't use much force to remove the bulb. Use tissue or napkin to install new bulb. The oils and acids in your fingers can damage the bulb and cause it to burn out prematurely.
Dec 10, 2011 at 7:26 PM
FACTORYJACK
- ✓ASE Certified Mechanic
- 4,159 POSTS
Remove the wheelhouse extension from either side(the failed one), and you will have access to the back of the lamp. Remove the screws and separate the back from the lense. You may find this easier by lifting and remove the appropriate front wheel.
Dec 10, 2011 at 7:47 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.