2005 Volkswagen Jetta Burning double the gas

2005 VOLKSWAGEN JETTA
148,000 MILES
Avatar
AREILAND
  • MEMBER
  • 1 POST
Just this past week my car has been burning double the gas. I can literally see my fuel gauge going down. I don't believe it is a leak. I usually get on average 300 miles on a full tank of gas, but this week it was 200. I went 80 miles and its just above half a tank. Also when I get below 1/8 of a tank it seem to stutter occasionally when i slow down and try to accel. Any advice would be greatful.
Oct 10, 2013 at 2:54 PM
Advertisement
Avatar
EXOVCDS
  • ASE Certified Mechanic
  • 1,883 POSTS
  • ASE Certified Mechanic
If the engine were running too rich, the ECM would throw a trouble code. Have someone check for stored codes (even if the
check engine light is not on), then have the same person check the fuel trim values with the scan tool. Idle trim values and
cruising trim values... anything in the range of +-5% can be considered normal.

Common issues are coolant temperature sensors, MAF sensors and thermostats that cause the engine to run cooler than
it should.

If the needle swings too much and when filling the tank, you can not put as much gas in as you think it needs... it could be
a fuel level sending unit issue (inside the gas tank).

If your Speedometer and odometer do not work (which can cause the fuel gauge needle to swing), replace the vehicle speed
sensor.

Thomas
Oct 10, 2013 at 5:04 PM
Avatar
EXOVCDS
  • ASE Certified Mechanic
  • 1,883 POSTS
  • ASE Certified Mechanic
Any progress?
Oct 11, 2013 at 6:17 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.