2005 Toyota Corolla problems in start

4 CYL • FWD • AUTOMATIC
Avatar
EPACHECO
  • MEMBER
  • 4 POSTS
Good night
My car is been giving problems about 4 months ago but its been in and out the mechanics. The problem is that the car when is cold start normal but when reach the operational temperature and you turned off after 45 minutes you try to strat the car again and won't start. The car make the starting but do not make the combustion in the engine. Is like the gasoline is not reaching to start but it have pressure. The fuel pump, the crank and camshaft sensor and the computer were change. Also de injectors were clean the oxigen sensor are good I have no others ideas. When the temperature of fhe car goes down its starts again and also if you put some gas direct in the engine also start. Does not give any codes .
Please help me I have no more ideas
Oct 1, 2014 at 11:02 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
When this happens, does the engine even try to start? Have you confirmed that it is getting spark and fuel?

Let me know.
Oct 1, 2014 at 11:14 AM
Avatar
EPACHECO
  • MEMBER
  • 4 POSTS
Yes it tries. And it confirmed is getting fuel and spark
Oct 1, 2014 at 11:21 AM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
If it is getting spark and fuel, it should run unless it's getting too much or too little. Has the coolant temp sensor been checked to make sure it isn't sending a false reading to the PCM?
Oct 1, 2014 at 11:39 AM
Avatar
EPACHECO
  • MEMBER
  • 4 POSTS
Thanks man I will
Oct 1, 2014 at 11:56 AM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
The CTS is a guess at this time. I have had vehicles not start or just run really bad with no trouble codes. If the PCM receives a signal from the CTS, it doesn't know if it is the right or wrong signal. The last issue I experienced was a van with no codes. The CTS was telling the computer it was -40 degrees F. As a result, the computer dumped fuel to make it run in those conditions.

It is just a thought. If you have access to a real time scanner, check the CTS signal to determine if it is working properly.
Oct 1, 2014 at 12:12 PM
Avatar
EPACHECO
  • MEMBER
  • 4 POSTS
How do I take that temperature, because my mecanic use te scaner to check and we wait until te 45 minutes pass and te temp was not high was normal we did this yesterday and also check te presure en the lines
Oct 1, 2014 at 8:59 PM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
Using a scanner, he can see the temp the sensor thinks it is.
Oct 1, 2014 at 9:39 PM
Avatar
EPACHECO
  • MEMBER
  • 4 POSTS
How I can check out this sensor
Oct 1, 2014 at 9:59 PM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
Use a scanner.
Oct 2, 2014 at 10:36 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement