How does one replace the HVAC Blower switch? Do you have to remove the glove compartment?
Jan 26, 2013 at 11:46 PM
2005 SUZUKI FORENZA
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
For replacing the blower motor switch you need to remove the control panel.
CONTROL ASSEMBLY REMOVAL AND INSTALLATION
Removal
1. Disconnect the negative battery cable.
2. Disconnect the mode control cable from the mode door.
3. Remove the center molding.
4. Disconnect the electrical connectors.
5. Disconnect the temperature control cable by gently prying the cable eyelet from the post on the controller. Unsnap the cable housing from the mechanical slide. Note the location of the cable and the housing for ease of installation.
6. Pull out the center molding.
7. Remove the four controller retaining screws.
8. Remove the control assembly from the center molding.
CONTROL ASSEMBLY REMOVAL AND INSTALLATION
Removal
1. Disconnect the negative battery cable.
2. Disconnect the mode control cable from the mode door.
3. Remove the center molding.
4. Disconnect the electrical connectors.
5. Disconnect the temperature control cable by gently prying the cable eyelet from the post on the controller. Unsnap the cable housing from the mechanical slide. Note the location of the cable and the housing for ease of installation.
6. Pull out the center molding.
7. Remove the four controller retaining screws.
8. Remove the control assembly from the center molding.
Jan 27, 2013 at 6:49 AM
Advertisement