replace a axle bearing hub assembly now my abs,brake stays on and the tire pressure light blinks how do I reset them I have pontiac 05 vibe
Dec 14, 2011 at 6:39 PM
my abs,brake stays on and the tire pressure light blinks
2005 PONTIAC VIBE
SHEILA JACKSON
- MEMBER
- 7 POSTS
Advertisement
FIXITMR
- ✓ASE Certified Mechanic
- 9,990 POSTS
Instructions
1
Park the vehicle and turn the engine off.
2
Turn the ignition switch to the "ON/RUN" position.
3
Press and hold the tire pressure warning reset switch until the TPMS light flashes on and off three times. The reset switch is located on the bottom of the steering column on most Pontiac vehicles.
4
Leave the ignition switch on for three to five minutes to give the computer a chance to reset and calibrate the system. Turn the ignition switch off.
you must have done something to ABS sensor on that wheel when you changed hub. recheck your work.
1
Park the vehicle and turn the engine off.
2
Turn the ignition switch to the "ON/RUN" position.
3
Press and hold the tire pressure warning reset switch until the TPMS light flashes on and off three times. The reset switch is located on the bottom of the steering column on most Pontiac vehicles.
4
Leave the ignition switch on for three to five minutes to give the computer a chance to reset and calibrate the system. Turn the ignition switch off.
you must have done something to ABS sensor on that wheel when you changed hub. recheck your work.
Dec 14, 2011 at 8:54 PM
All three lights came on same time tire pressure light blinks.
May 5, 2025 at 11:06 AM
STRAILER
- ✓ASE Certified Mechanic
- 54,848 POSTS
Yep this happens when one of the tire pressure sensors goes out, you will need to do a CAN scan to see which one it is.
This video will show you how:
https://youtu.be/u-4syLc-ifQ
Please go over this guide and get back to us.
This video will show you how:
https://youtu.be/u-4syLc-ifQ
Please go over this guide and get back to us.
May 5, 2025 at 11:42 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.