headlight replacement

2005 PONTIAC MONTANA
99,000 MILES
Avatar
FPULL
  • MEMBER
  • 1 POST
Wanting to replace headlamp on my montana. have the bolt and pin out, but must be some other retainer behind.
Apr 22, 2011 at 2:08 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,828 POSTS
Remove two wing nuts then lift up and pull forward see diagram. Lamp filled with nitrogen Must lay lnes flat down on cloth before removing bulb
Image (Click to enlarge)
Attached Media
Apr 22, 2011 at 2:15 PM
Advertisement
Avatar
RALPHIE1234
  • MEMBER
  • 2 POSTS
how do I replace the headlight bulbs?
Dec 22, 2020 at 5:53 PM (Merged)
Avatar
BLUELIGHTNIN6
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 16,542 POSTS
replacing the whole assembly or just the bulbs?
Dec 22, 2020 at 5:53 PM (Merged)
Avatar
RALPHIE1234
  • MEMBER
  • 2 POSTS
the whole assembly
Dec 22, 2020 at 5:53 PM (Merged)
Avatar
BLUELIGHTNIN6
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 16,542 POSTS
the bulbs are removed from rear of assembly after removing headlight assembly. there are two wing nuts securing the entire plastic headlight assembly. One is mounted at the top-inboard(towards engine), And the other is outboard of the assembly. Once these two wingnuts are removed, carefully remove the whole assembly
Dec 22, 2020 at 5:53 PM (Merged)