2005 Nissan Murano Brakes

2005 NISSAN MURANO
96,000 MILES
Avatar
STUMPED2OBILIVION
  • MEMBER
  • 2 POSTS
Took my car in for an oil change. Shop said I needed brake pads on the rear and rotors resurfaced I said go ahead and do it. Its been approximately 2,000 miles since this was done and I am now having issues with the left rear brake. At first I thought I had a bad tire so I replaced all 4 tires and this did not resolve the issue. Left rear brake is very hot after car is driven just a few miles and I here an awful noise when car is going about 40 to 50 miles an hour. What could be the problem?
Jul 14, 2013 at 1:11 PM
Advertisement
Avatar
OBXAUTOMEDIC
  • ASE Certified Mechanic
  • 3,711 POSTS
  • ASE Certified Mechanic
Hello,

Ok, one possibility is the Brake Caliper Sticking, Another is a Failing Brake Hose, and yet another is the E-Brake (Emergency Brake).

When the rear brakes were done did they say anything about the e-brake. Do you use the e-brake a lot?
Jul 14, 2013 at 1:33 PM
Avatar
STUMPED2OBILIVION
  • MEMBER
  • 2 POSTS
I was told the e-brake was in very good operation and I do not use it very much.
Jul 14, 2013 at 1:50 PM
Avatar
OBXAUTOMEDIC
  • ASE Certified Mechanic
  • 3,711 POSTS
  • ASE Certified Mechanic
Ok, what you can do is jack up the rear of the vehicle, spin the left rear wheel if won't spin try opening the Bleeder valve on the caliper.... If brake releases then most like to brake hose has failed and will need to be replaced.

If doesn't release then could be the caliper sticking or the caliper bolts/slides are sticking and just need to be cleaned and relubed.
Jul 14, 2013 at 8:17 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.