Thermostat location and replacement?

Tiny
MARCYMODJ
  • MEMBER
  • 5 POSTS
I'm having the same issue.I need to set it to heat for the winter. I had my mechanic do it last year but he's unreachable now. For heat do I pull or push the cable? Could you give me step by step directions? Thank you so much, Marcie
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:48 AM (Merged)
Tiny
DNCKADLEC
  • MEMBER
  • 1 POST
  • 2001 NISSAN ALTIMA
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 13,000 MILES
I need to replace the thermostat on my Nissan Altima. Can you tell me where the thermostat is and give me some info on how to replace it. Thank you!
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:49 AM (Merged)
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Hi dnckadlec,

It is located at the end of the lower radiator hose at engine block.

You need to detach the hose and then remove the housing to get at the thermostat.

It is below the distributor at the air relief plug area.


https://www.2carpros.com/forum/automotive_pictures/192750_ReliefPlug01NissanAltima_1.jpg

Was this
answer
helpful?
Yes
No
+1
Monday, February 15th, 2021 AT 11:49 AM (Merged)
Tiny
QLTYFIRST
  • MEMBER
  • 1 POST
  • 2000 NISSAN ALTIMA
  • 6 CYL
  • FWD
  • MANUAL
  • 111,000 MILES
How do I replace the thermostat in a 2000 NIssan Altima? Is it difficult for someone who has done little mechanical work? Where do I find instructions?
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:49 AM (Merged)
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Its a piece of cake-see location below
Was this
answer
helpful?
Yes
No
-1
Monday, February 15th, 2021 AT 11:49 AM (Merged)
Tiny
WILLIECBROWN
  • MEMBER
  • 3 POSTS
  • 1999 NISSAN ALTIMA
  • 4 CYL
  • FWD
  • AUTOMATIC
Install thermostatic on nissan alt
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:49 AM (Merged)
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Thermostat

Be careful not to spill coolant over engine compartment. Use a rag to absorb coolant.

Inspection

Check valve seating condition at normal room temperatures. It should seat tightly.

Check valve opening temperature and valve lift.
Then check if valve is closed at 5°C (9°F) below valve opening temperature.
Installation

Install thermostat with jiggle valve or air bleeder at upper side.

Apply a continuous bead of liquid gasket to mating surface of water inlet.
After installation, run engine for a few minutes, and check for leaks.
Was this
answer
helpful?
Yes
No
-1
Monday, February 15th, 2021 AT 11:49 AM (Merged)
Tiny
ERICKN8318U
  • MEMBER
  • 7 POSTS
  • 1995 NISSAN ALTIMA
  • 130,000 MILES
I replaced my radiator and thermostat after the old radiator cracked, but I used a Gates 180° thermostat instead of the OE 170° thermostat. Since installing it 3 days ago, I've only been able to get the thermostat to open once, when it was a sunny warmer day. Lately on cooler days (50°) the thermostat does not even open while driving uphill at high rpm (lower radiator hose stays very cool), and the engine doesn't seem to get very hot at all (the fan blows quite a bit though). Meanwhile since the thermostat isn't opening, it seems like my upper and lower radiator hoses are bulging with pressure since the coolant isn't circulating through the thermostat--can it sustain that? At the same time, I've noticed that even though the engine is warm, the heater takes awhile to put out heat, and sometimes intermittently puts out very warm heat or no heat. Could there still somehow be more air in the system causing that heater problem, or something else (vacuum?) Causing it? (I already followed the instructions using the air bleed bolt, etc to remove the air from the coolant system.)
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
ERICKN8318U
  • MEMBER
  • 7 POSTS
The title should have said "heater NOT consistently putting out heat!"
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
If both your heater hoses arent getting hot and the thermostat isnt opening I would suggest replacing the thermostat with the stock oe temp one it could be a bad new one that has happened to me.I would use a stant one I have always had good luck with that brand. As far as the hoses bulging they could be weak and need replacing. As far as your heater goes are both the heater hoses going into the heater core getting really hot with the heater on?
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
ERICKN8318U
  • MEMBER
  • 7 POSTS
After a bunch more trial runs and trying to get air out of the system (the hoses are brand new BTW, and not exactly bulging I guess), I've found that sometimes both heater hoses are hot with the heater on, and sometimes only one is hot. With the front of the car jacked up, running the vehicle shows a constant stream of bubbles gurgling into the coolant reservoir, and the car seems to maintain normal temperature fine. Could air be being pulled into the heater control valve or somewhere, causing air in the system constantly? But there doesn't seem to be any coolant leaking anywhere. I don't know why the heater problem is only intermittent. Haven't seen any fogging inside the vehicle (which would indicate leaking heater core).
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
ERICKN8318U
  • MEMBER
  • 7 POSTS
Also, there is no coolant in the oil, and no sign of coolant being burned in the exhaust.
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
ERICKN8318U
  • MEMBER
  • 7 POSTS
(oh, and the thermostat is opening fine, it just takes a lot of revving to heat things up enough since it's a 180-degree thermostat.)
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
The first thing I would do is to put the stock temp thermostat back in. Then bleed the air out of the cooling system I posted how to do that for you.
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
ERICKN8318U
  • MEMBER
  • 7 POSTS
Thanks for the tips, I followed the instructions with the stock thermostat, but it still had constant bubbling in the coolant reservoir. A block tester kit revealed exhaust gases in the coolant. Guess it's time for a new head gasket even though there were no obvious symptoms.
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Glad to hear you figured it out but sorry to hear the exhaust gases in the coolant. When you have the head off have the head pressure tested and make sure your valves are good also. Then have the head surfaced also straight edge your block and look for cracks. Let me kwow how it comes out.
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
ERICKN8318U
  • MEMBER
  • 7 POSTS
I had a shop do the job and they had the head pressure tested and machined and said everything else was good besides the slightly failing head gasket. Seems to be running fine without the air now!
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Glad to hear you got the car running good thats what we like to hear.
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
JOTA2
  • MEMBER
  • 8 POSTS
  • 1995 NISSAN ALTIMA
1995 Nissan Altima 155000 miles

engine will not heat up in cold weather. Thermostat replaced twice. Fluid level has been chkd. New radiator installed for an un related problem
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)
Tiny
ZACKMAN
  • MECHANIC
  • 4,202 POSTS
Did you check the heater core to see if it is clogged?
Was this
answer
helpful?
Yes
No
Monday, February 15th, 2021 AT 11:50 AM (Merged)

Please login or register to post a reply.

Sponsored links