2005 Nissan Almera Had Crank Shaft Sensor Replaced By Garage Last Week Since

2005 NISSAN ALMERA
45,000 MILES
Avatar
ANGEL52
  • MEMBER
  • 1 POST
I had the Crank Shaft sensor replaced by garage last week and since then the idle rev are too high at about 1100 rpm whereas before garage did work the revs were 850 rpm.
The garage have said problem not connected - I would like to know if the revs would be affected by then fitting new sensor and also is it easy to reduce revs ?
Nov 19, 2012 at 12:24 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
They aren't connected. CHeck the IAC and also check to see if there are any vacuum leaks.
Nov 19, 2012 at 1:20 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.