how to remove power steering pump
Feb 13, 2013 at 12:08 AM
2005 Mazda Tribute Remove Power Steering Pump
2005 MAZDA TRIBUTE
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
ASEMASTER6371
- ✓ASE Certified Mechanic
- 52,796 POSTS
Removal
Remove the drive belt.
Using the special tool, remove the power steering pump pulley.
Installation
Caution: Install a new power steering pump pulley after the second removal and installation.
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, install a new pulley. If there is no paint or one paint mark, use a paint pencil to mark the web area of the pulley near the hub. Using the special tool, install the power steering pump pulley.
Install the accessory drive belt.
© 2013 ALLDATA LLC. All rights reserved. Terms and Conditions
since you provided no info on the motor, i assumed it was a v-6
Roy
Remove the drive belt.
Using the special tool, remove the power steering pump pulley.
Installation
Caution: Install a new power steering pump pulley after the second removal and installation.
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, install a new pulley. If there is no paint or one paint mark, use a paint pencil to mark the web area of the pulley near the hub. Using the special tool, install the power steering pump pulley.
Install the accessory drive belt.
© 2013 ALLDATA LLC. All rights reserved. Terms and Conditions
since you provided no info on the motor, i assumed it was a v-6
Roy
Feb 13, 2013 at 12:23 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.