torque converter

2005 KIA AMANTI
6 CYL • 2WD • AUTOMATIC
Avatar
MWDIERKS
  • MEMBER
  • 5 POSTS
I am replacing my engine and as I was putting the engine back the torque converter was falling out. Is it fine to push it back in on the gears?
Aug 3, 2011 at 10:49 PM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
It must be aligned with the pump drive and the splines, best way to fit is to support with one hand and spin the converter slowly until it drops into place, have the nose of the transmission up a bit so gravity helps as well.
Aug 4, 2011 at 2:47 AM
Avatar
MWDIERKS
  • MEMBER
  • 5 POSTS
Thanks, I slowly rotated it and slid it back on.
Aug 4, 2011 at 11:11 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.