torque converter

2005 KIA AMANTI
6 CYL • 2WD • AUTOMATIC
Avatar
MWDIERKS
  • MEMBER
  • 5 POSTS
I am replacing my engine and as I was putting the engine back the torque converter was falling out. Is it fine to push it back in on the gears?
Aug 3, 2011 at 10:49 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
It must be aligned with the pump drive and the splines, best way to fit is to support with one hand and spin the converter slowly until it drops into place, have the nose of the transmission up a bit so gravity helps as well.
Aug 4, 2011 at 2:47 AM
Advertisement
Avatar
MWDIERKS
  • MEMBER
  • 5 POSTS
Thanks, I slowly rotated it and slid it back on.
Aug 4, 2011 at 11:11 PM