2005 GMC JIMMY
10,000 MILES
Avatar
BLKBOT
  • MEMBER
  • 1 POST
I am getting code 1301 on BCM module. and no start after it has been driven for a couple or hours but starts up in the mornings of after it sits for a couple of hours. No security light on or steady. It will start after 10m min relearn. Is it the wireing or the BCM module that is more likely the cause.
Mar 9, 2013 at 10:53 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
this is low voltage going between circuits and module are not communicating with each other. you really need a pro type scan tool to see what is going on it could be a wiring problem or it cold be something else like shorting out.
Mar 10, 2013 at 3:37 PM
Advertisement