The bearing went out and was in pieces when I got the drum off of the car.

2005 FORD FOCUS
Avatar
LHALL
  • MEMBER
  • 1 POST
I am trying to replace the rear wheel bearing on a 2005 ford focus and would like to know the best way to get the old bearing out of the drum. I do not have a press and have removed a snap ring.
Dec 26, 2011 at 9:34 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
If this is a 2wd, you should be able to just tap them out from the opposite side.
Dec 26, 2011 at 9:35 PM
Avatar
LHALL
  • MEMBER
  • 1 POST
I have ben trying that but it has not worked, should I be using a piece of pipe or something to put against the part that is still in the drum
Dec 26, 2011 at 9:40 PM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
You could do that. Make sure the removal area isn't blocked. For example, place the drum on something that will allow room for the old bearing to come out.
Dec 26, 2011 at 10:02 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle