Removal and Installation
Remove the 4 transaxle roll restrictor brace bolts.
To install, clean the bolts using a wire brush, apply new threadlocker to the threads and tighten to 55 Nm (41 lb-ft) .
Remove the bolt and the transaxle roll restrictor brace.
To install, clean the bolts using a wire brush, apply new threadlocker to the threads and tighten to 48 Nm (35 lb-ft) .
Disconnect the exhaust gas recirculation (EGR) system module vacuum tube and electrical connector.
Disconnect the EGR system module-to-EGR system module tube fitting.
To install, tighten to 40 Nm (30 lb-ft) .





NOTE: When installing the EGR system module, install a new EGR system module gasket with the side with the raised ring facing the intake manifold.
Remove the 2 bolts and the EGR system module.
To install, tighten to 25 Nm (17 lb-ft) .
To install, reverse the removal procedure.