2005 Dodge Durango taillight issue

2005 DODGE DURANGO
100,000 MILES
Avatar
SPENCERBRYAN71
  • MEMBER
  • 1 POST
I tried wiring in trailer lights by myself, I must have shorted out the circuit board inside because now I have nothing on that side, the driver side, which is the side I was wiring from, all the wires come down that side on inside of suv. Things have changed a lot, used to be able to just jumper the wires and u were good to go....pass. side is fine. Should have bought wiring harness, tightwad. Can I just buy the circuitboard?
Jul 16, 2013 at 6:48 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CJ MEDEVAC
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 11,004 POSTS


I SORTA DON'T KNOW WHAT KINDA CONNECTOR YOU WERE INSTALLING

THIS ONE IS THE FLAT 4 PRONG TYPE.......I THINK THERE IS THE SAME SORTA SET-UP FOR THE ROUND ONES

YOU SIMPLY TAKE THE CONNECTOR APART UNDER THE VEHICLE AND THIS HARNESS "TEEs IN" BETWEEN THEM

http://shop.advanceautoparts.com/webapp/wcs/stores/servlet/product_towing-plug-in-electrical-t-connector-reese_22080180-p?searchTerm=trailer+wiring+kit

NO SPLICING....NO HASSLE......IF YOU BUY THE RIGHT ONE

AS FAR AS THE CIRCUIT BOARD......I LOOKED AT SEVERAL ON-LINE PARTS STORES....I AIN'T SEE-UN ONE!

I DID FIND YOU A DIAGRAM FOR EXTERIOR LAMPS IN "MITCHELL I"

FULL DIAGRAM......THEN I'M "CROPPING/ CHOPPING" IT IN HALF........MAYBE YOU WILL BE ABLE TO SEE IT BETTER

YOU SHOULD BE ABLE TO SEE THE FUSES IN THIS SYSTEM, AND ANYTHING ELSE YOU COULDA .......WELL....."MUFFED"!...................THESE MITCHELL DIAGRAMS USUALLY LIST THE LOCATIONS OF THE COMPONENTS

....................IS THE STORE IN MY LINK A LOCAL STORE FOR YOU?....IF SO, LEMME KNOW BEFORE YOU BUY ANYTHING ELSE!

YOUR TURN

THE MEDIC
Jul 16, 2013 at 8:31 PM
Advertisement