Hi,
You are correct. From the radiator, it is steel, then rubber, then back to steel. As far as repairs are concerned, the rubber hose isn't serviceable because it is crimped with the steel line.
Replacing it isn't too bad, but if the truck isn't off the ground, you won't get it into position. It needs to be fed over the axle and won't bend enough unless it is relatively high for clearance. Also, it is a little tight, based on which one has failed, to access the retainer on the transmission itself.
As far as replacement is concerned, I recommend doing both at the same time. If one has failed, the other isn't far behind.
I attached information related to removing the quick connectors. They can be a bit of a pain if you don't have the right tools. The tool indicated is Chrysler part 8875A which is a small removal tool with a large price tag. See pic one.
There is a small horseshoe retainer clip you can't even see. LOL First, there is a dust plastic cover over the connector that you can gently pry backward. Once that is done, you will have access to the retainer clip I mentioned. I always use a small pic to carefully remove the clip. Once it's removed, the line will come out. Do the opposite to install. Just make sure the line is fully installed before you reinsert the clip. Additionally, the plastic dust cover prevents the clip from falling out, so make sure you reseat it.
I attached the directions below from my manual, but they are for using the tool. You could ask at a parts store if they have one that would work that they lend.
Let me know if this helps or if you have questions.
Take care,
Joe
See pics below.
Images (Click to enlarge)
Feb 2, 2024 at 10:10 PM
