plow required to run truck

2005 DODGE DAKOTA
105,000 MILES
Avatar
MIKE CHOUINARD
  • MEMBER
  • 3 POSTS
i have a 2005 dodge dakota with a snowbear plow on it that runs by a winch it has a up and down button a control box under the hood with a possitive wire a negitive wire that goes to the battery and the wires that goes to the winch
Mar 12, 2012 at 9:39 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
look for a switch on the plow tht is connected to your battery or another kill switch.
Mar 12, 2012 at 10:39 PM
Advertisement
Avatar
MIKE CHOUINARD
  • MEMBER
  • 3 POSTS
i completly took all connections of the plow off the truck so its like it never had one and it still wont start its like what ever burned the fuse at the batter also burned some thing out in the truck that stops it from starting . it turns over just dont start
Mar 13, 2012 at 9:53 PM
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
have you checked the fuses in the integrated power module? especially fuse 36, 33 and the auto shutdown relay.then if they are ok scan for codes to seee if any sensors are giving you aproblem. Check fuel pressure as well.
Mar 14, 2012 at 7:20 PM