2005 Chrysler Pt Cruiser Keep Getting P0344 Code Even Though Changed Camshaft

2005 CHRYSLER PT CRUISER
106,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I keep getting a p0344 code even though i have changed the camshaft sensor multiple times and all wiring is new, could it be doing this because i dont let the car warm up?
Dec 2, 2012 at 2:17 PM
Advertisement
Avatar
ASEMASTER6371
  • ✓ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
a code never identifies a bad part just a failed system

Test 1 - 2


Test 3 - 6


Test 7 - 11


Test 12



SYMPTOM
P0344-CAMSHAFT POSITION SENSOR INTERMITTENT

WHEN MONITORED
Engine running or Cranking.

SET CONDITION
When the failure counter reaches 20. One Trip Fault.

POSSIBLE CAUSES

Good trip equal to zero
Wiring harness inspection
(K7) 5 volt supply circuit open or shorted to ground
Tone wheel/pulse ring inspection
Checking CKP signal with the DRBIII(R) lab
Camshaft position sensor
(K44) CMP signal circuit open
(K44) CMP signal circuit short to ground
(K44) CMP signal circuit shorted to B+
(K44) CMP signal circuit short to (K7) 5 volts
PCM


Dec 2, 2012 at 3:23 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.