2005 Chrysler Pacifica You Tell Heater Mode Door Actuator On Pacifica Ve Under

2005 CHRYSLER PACIFICA
80 MILES
Avatar
DOUG.O
  • MEMBER
  • 2 POSTS
Can you tell me where the heater mode door actuator is on a 2005 Chrysler pacifica. I've look under the dash on the drivers side insterment panel and can't find it.

Thank you Doug
Nov 16, 2012 at 6:53 PM
Advertisement
Avatar
STRAILER
  • ASE Certified Mechanic
  • 54,840 POSTS
  • ASE Certified Mechanic
Hello,

Here is a guide to show you what you are in for when doing the job and the diagrams for your car below:

https://www.2carpros.com/articles/replace-blend-door-motor

Check out the diagrams (below). Please let us know if you need anything else to get the problem fixed.

Cheers, Ken
Jun 9, 2018 at 10:43 AM
Avatar
ERNIE SHORES
  • MEMBER
  • 2 POSTS
2007 Chrysler Pacifica. Where is the blend door located?
Feb 5, 2022 at 1:22 PM
Avatar
SQM
  • ASE Certified Mechanic
  • 6,383 POSTS
  • ASE Certified Mechanic
Hello,

This vehicle has two blend door actuators (for dual zone HVAC). One for the driver side and the other for the passenger side.

They are located on the HVAC box; you can access them from under the driver side dash by removing the silencer.

https://www.2carpros.com/articles/replace-blend-door-motor

I have attached the diagrams below.

Please let me know if you have any questions.
Thank you.
Feb 5, 2022 at 9:13 PM
Avatar
ERNIE SHORES
  • MEMBER
  • 2 POSTS
Thanks, helped.
Feb 6, 2022 at 5:30 PM
Avatar
SQM
  • ASE Certified Mechanic
  • 6,383 POSTS
  • ASE Certified Mechanic
You are welcome.
Feb 6, 2022 at 6:57 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.