chevy equinx 2005

45,000 MILES • V8 • AWD • AUTOMATIC
Avatar
NMEASE
  • MEMBER
  • 5 POSTS
i have a 2005 chevy equinox and i have replaced a fuse repeatedly for a couple of weeks now. when i try to start it the dash lights come on but it wont start. so i have been changing the fuse but then it blows out. my husband wants to try to fix it himself before he takes it to the shop. any advice as to what might be the problem?
May 4, 2011 at 11:51 AM
Advertisement
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
Where is the fuse, underhood, interior? What is the amp rating, what does the fuse control? Your owners manual should tell what circuit/s the fuse controls.
May 4, 2011 at 12:03 PM
Avatar
NMEASE
  • MEMBER
  • 5 POSTS
its under the hood. it has a number 10 on it. all the dash lights come on and it just wont crank at all or turn over. the fuse that i replace i think controls the back up lights. but...when i actually back up the lights are on and seem ok. i looked in my book and all it says is what that fuse controls.
May 4, 2011 at 12:36 PM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
Below should be the underhood fuseblock, recognize anything?
May 4, 2011 at 1:45 PM
Avatar
NMEASE
  • MEMBER
  • 5 POSTS
yes the 10A fuse where it says backup. this happened 2 years ago and i had the car at the shop and the mechanic said it was a back up light that blew the fuse and it triggered the anti theft???? my back up lights work though..i dont know at this point just tired of changing fuses everytime i get in my car
May 4, 2011 at 2:00 PM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
When the problem occurs, does the starter crank? Cranking and starting are two different issues.
May 4, 2011 at 2:26 PM
Avatar
NMEASE
  • MEMBER
  • 5 POSTS
no starting at all just lights coming on. no noise at all
May 4, 2011 at 2:32 PM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
Look at the neutral switch, my info says, on top of tranny. Anything look burned or melted? The next thing would be to separate the backup lamp circuit from the neutral switch. Next, you check the circuit from the neutral switch to pcm.

If the fuse is blown, the backup lamps can't work.
May 4, 2011 at 3:09 PM
Avatar
NMEASE
  • MEMBER
  • 5 POSTS
thanks for all your help i will try this
May 5, 2011 at 5:08 AM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
No problem.
May 20, 2011 at 8:34 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement